Sublimation Ready Frosted Shot Glasses, 1.5oz or 3oz Frosted, sublimation blank shot glasses RTS
Sublimation Ready Frosted Shot Glasses, 1.5oz or 3oz Frosted, sublimation blank shot glasses RTS
Product Type
Sublimation-Ready Frosted Shot Glasses
Product Details
- Sizes: 1.5oz or 3oz
- Material: Frosted Shot Glass
- Usage: For use in a mug/tumbler press or convection oven.
Convection Oven Directions
PLEASE NOTE:
- equipment varies and so may your required settings.
- Please test your equipment using these baseline recommendations.
Shrink Wrap:
Convection oven requires the use of shrink wrap to apply pressure during baking, sold separately.
Application:
- Apply sublimation transfer on the surface of the glass using heat tape.
- For full wrap designs, make sure you pull the transfer as tightly as possible around the tumbler, then tape very well along the seam,
- Pulling the tape/transfer as tight as possible with no air pockets.
- If your transfer does not fully cover the tumbler surface, apply blowout/butcher paper to the entire tumbler so that there is no glass showing on the sides (Protects the cup from shrink wrap).
- Apply shrink wrap using a heat gun to shrink it tight to the glass can.
Baking Instructions
- Bake in a convection oven at approximately 375 degrees F for 6.5 minutes, turning halfway.
- Remove from oven and immediately remove shrink wrap and transfer.
- GLASS WILL BE HOT!!
- No sealant is necessary on sublimation.
- Hand washing is recommended as the high heat in many dishwashers may reactivate the ink and cause it to bleed.
- As with all glass products, avoid extreme temperature changes, as this may cause cracking or even explosion of the glass.