Sublimation or Laser Engraving Mini "Shot Glass" Tumbler with lid and straw RTS

Product Type

Mini Shot Glass Tumbler

Product Description

This mini-shot glass tumbler is perfect for sublimation and engraving projects.

With a 2-3 oz capacity (2 oz with lid on, 3 oz without lid), it includes a lid and straw.

Ideal for customizing with vibrant sublimation designs or laser engraving.

Product Details

• Capacity: Approximately 2 oz with lid; 3 oz without lid
• Material: Sublimation-ready (all colors)
• Includes: Lid and straw
• Features: Can be engraved with a laser

Note:

• Convection oven requires the use of shrink wrap to apply pressure during baking, sold separately.
• Accessories such as rubber bottoms and straw-cleaning brushes are also available in a separate listing.

Directions

PLEASE NOTE:

• equipment varies and so may your required settings.
• Please test your equipment using these baseline recommendations.

Sublimation:

• Apply sublimation transfer on the surface of the tumbler using heat tape.
• For full wrap designs, make sure you pull the transfer as tightly as possible around the tumbler, then tape very well along the seam and around the top/bottom of the tumbler.
• Pulling the tape/transfer as tight as possible with no air pockets.
• If your transfer does not fully cover the tumbler surface, apply blowout/butcher paper to the entire tumbler so that there is no metal showing on the sides.

Convection Oven:

• Apply shrink wrap using a heat gun to shrink it tight to the tumbler.
• Bake in a convection oven at approximately 385-400 degrees F for 5-6 minutes, turning halfway.
• If your tumbler is touching a metal surface during baking, the shrink wrap will be more likely to melt!
• Remove from oven and immediately remove shrink wrap and transfer.
• TUMBLER WILL BE HOT!!

Note:

• No sealant is needed.
• Hand wash is recommended to avoid bleeding due to high dishwasher temperatures.

Additional Information

• Equipment may vary, so test with these baseline recommendations.