Skip to product information
1 of 4

ACC Sublimation Blanks & Designs

4in1 Can Cooler with Bluetooth Speaker, Speaker Can Cooler, 4in1 glossy RTS

4in1 Can Cooler with Bluetooth Speaker, Speaker Can Cooler, 4in1 glossy RTS

Regular price $22.00 USD
Regular price Sale price $22.00 USD
Sale Sold out
Shipping calculated at checkout.
Speaker Color

4in1 can cooler for sublimation. 4in1 can cooler holds regular cans, skinny cans, most bottles, and can also be turned into a tumbler with the included extra screw on lid. (rubber bottom or metal straw sold separately if desired)

Choice of color for the Bluetooth speaker. Bluetooth speakers are water resistant and include charging cable. *Remove speaker from bottom of tumbler before sublimating or washing.

Shiny white sublimation coating that produces vibrant colors. For use in a mug press or convection oven. Convection oven requires the use of shrink wrap to apply pressure during baking, sold separately, and accessories such as rubber bottoms and straw cleaning brushes are also available in a separate listing.


***Directions*** PLEASE NOTE: equipment varies and so may your required settings. Please test your own equipment using these baseline recommendations.

Apply sublimation transfer on the surface of the tumbler using heat tape. For full wrap designs, make sure you pull the transfer as tightly as possible around the tumbler, then tape very well along the seam and around the top/bottom of the tumbler. Pulling the tape/transfer as tight as possible with no air pockets. If your transfer does not fully cover the tumbler surface, apply blowout/butcher paper to the entire tumbler so that there is no metal showing on the sides.


*Tumbler Press* (Equipment settings and functions may vary. These settings are on our Elite Pro Max tumbler press offered in the shop)             

 Press at 360°F for 60 seconds, then turn the tumbler halfway and press again for another 60 seconds. If the design is darker, an additional few seconds may be required. Remove transfer and let cool.

*Convection Oven* (Equipment settings will vary!)

Apply shrink wrap using a heat gun to shrink it tight to the tumbler.

Bake in a convection oven at approximately 385-400 degrees F for 5-6 minutes, turning halfway. **If your tumbler is touching a metal surface during baking, the shrink wrap will be more likely to melt!

Remove from oven and immediately remove shrink wrap and transfer. TUMBLER WILL BE HOT!!

No sealant is necessary on sublimation tumblers. *Hand washing is recommended as the high heat in many dishwashers may reactivate the heat and cause it to bleed.


View full details